新2手机会员端网址(中国)责任有限公司

新2手机会员端网址
热线电话:400-879-1999 山汽官方微信
郑重声明 购机 售后
在线询价
热线电话:400-879-1999
您现在所在的位置: 首页> 新闻资讯 > 公司新闻

自上料搅拌车散热系统故障排除法

所属分类:公司新闻 发布时间:2022-10-17 来源: 浏览量:0

1、检查保险开关:
1. Check the fuse switch:
自上料搅拌车是通过液压传动系统来驱动罐体的,液压油散热系统中容易出现故障的就是保险开关,因此在故障发生后,一时间检查保险开关。
The self feeding agitator truck drives the tank through the hydraulic transmission system. The safety switch is the one that is easy to fail in the hydraulic oil cooling system. Therefore, check the safety switch at once after the failure occurs.
2、检查驱动风扇:
2. Check the drive fan:
电机是整个散热系统中为关键的部件,散热效果的好与坏,和电机的转速及运行的平稳状态有着直接的关系,它由连接车辆电瓶的电控盒直接供电,用电力驱动电机高速运转,来带走热交换器当中的额热量,给液压油降温。
The motor is the key component in the whole heat dissipation system. The good or bad heat dissipation effect is directly related to the motor speed and stable running state. It is directly powered by the electric control box connected to the vehicle battery. The motor is driven by electricity to run at a high speed to take away the current heat of the heat exchanger and cool the hydraulic oil.
3、检查热交换器:
3. Check the heat exchanger:
自上料搅拌车利用液压油散热器来进行降温。热交换器上装有电机驱动风扇进行散热,让液压油正常工作,上面的机械式指针通过检测管路当中的负压,如果出现读数证明液压油滤清器可能出现堵塞,刚开始出现的时候只需要拔掉上面的橡胶指针归零,如果后面还出现读书且拔掉橡胶塞之后还解决不了的话,就需要更换液压油滤芯了。
The hydraulic oil radiator is used to cool the self feeding mixer. The heat exchanger is equipped with a motor driven fan to dissipate heat, so that the hydraulic oil can work normally. The mechanical pointer above detects the negative pressure in the pipeline. If there is a reading that indicates that the hydraulic oil filter may be blocked, it is only necessary to remove the rubber pointer above to zero at the beginning. If there is a reading that cannot be solved after the rubber plug is removed, the hydraulic oil filter element needs to be replaced.
4、检查热传感器:
4. Check the thermal sensor:
温度传感器位于热交换器的进油管上,它的作用就是检测液压油的温度,自上料搅拌车散热系统发生故障后,如果确认不是保险的问题,那就检查温度传感器。
The temperature sensor is located on the oil inlet pipe of the heat exchanger, and its function is to detect the temperature of the hydraulic oil. If it is confirmed that the cooling system of the charging mixer is not a problem of insurance after the failure, check the temperature sensor.
5、检查散热器控制盒:
5. Check radiator control box:
散热控制盒监控和接受温度传感其传递过来的信号,当温度数据超过设定值后,自动接通散热风扇的电路,让空气流通降低液压油的温度,因此散热控制盒损坏后,散热系统就不能正常工作,需要及时更换,一般情况下,散热器控制盒不容易损坏。
The heat dissipation control box monitors and receives the signal transmitted from the temperature sensor. When the temperature data exceeds the set value, the circuit of the heat dissipation fan is automatically connected to allow air circulation to reduce the temperature of the hydraulic oil. Therefore, the heat dissipation system cannot work normally after the heat dissipation control box is damaged, and it needs to be replaced in time. Generally, the heat dissipation control box is not easy to be damaged.
自上料搅拌车
Self feeding mixer truck

 

首页 产品 电话 置顶
Baidu
sogou